It does not hear the interviewer
The interviewer's words do not show in the transcript, or show as yours. Fix your computer's sound on Mac and Windows.
Windows and Mac · 3 min read
How MeetAssist hears the interviewer
MeetAssist hears the interviewer through your computer's sound, shown as Audio in the toolbar, and hears you through Mic. A green dot means it works, yellow means it is connecting, and red with the word Off means it cannot get the computer's sound. Your own words show dimmer than the interviewer's.
Fixes
On a Mac: "System audio needs Screen Recording permission"
macOS does not let MeetAssist record the computer's sound yet. Until you allow it, MeetAssist hears only your microphone.
- Click Grant access, in the message or next to Audio. The card Enable system audio opens, and so does System Settings.
- Turn on MeetAssist under Screen & System Audio Recording and, on newer macOS, under System Audio Recording Only.
- Restart MeetAssist: macOS applies this permission only after a restart. Press Restart MeetAssist if you see it. Otherwise press Stop, close MeetAssist with × at the top right, and open it again.
"Could not capture system audio"
Getting the computer's sound failed although nothing blocks it. On Windows this is the message you see, because Windows needs no permission for it.
- Click Retry in the message.
- Make sure the call plays on this computer, through speakers or headphones that are plugged in or connected.
- Still red: press Stop and Start session again.
The dots are green, but the interviewer's words never appear
The call plays through a sound device MeetAssist is not listening to, so it hears silence. This can happen with headsets, Bluetooth headphones and virtual audio devices.
- On Windows, click System Audio next to Audio. Choose Auto (Recommended): it listens to the default device and to the one Windows uses for calls, marked Calls (Teams, Discord). If the call plays on yet another device, pick that device.
- If you picked a device by name and then switched to other headphones, pick the new ones, or Auto, which follows the device Windows switches to.
- In Zoom, Teams or Meet, check which speaker the call uses. Choose your real speakers or headphones, not a virtual device.
- On a Mac, MeetAssist hears everything the Mac plays. Make sure the call runs on this Mac and not on another device.
The interviewer's words show dimmer, like my own
MeetAssist does not get the computer's sound and hears the interviewer only through your microphone. It takes those words as yours, so automatic answers skip them.
- Fix the computer's sound with the steps above.
- Until then, press Answer after each question.
The interviewer's words show up twice
With speakers, the interviewer's voice also reaches your microphone and is written again as yours.
- Use headphones.
The transcript is nonsense or in the wrong language
The language set for the call is not the one being spoken.
- Click Lang in the toolbar and pick the language the interviewer speaks. See An interview in another language.
The words stop for a while and the toolbar says it is reconnecting
The internet connection dropped or slowed down. MeetAssist reconnects by itself.
- Check your internet, and turn off VPN if you use one.
- If a message says the connection was lost, press Stop and start the session again.
On an older Mac
Recording the computer's sound needs macOS 13 (Ventura) or newer. On older versions MeetAssist hears only your microphone.
- Update macOS if your Mac can run a newer version.
Still not working? Contact support and say what the toolbar shows next to Audio.
See also
Still stuck?
Write to us. A real person answers, usually the same day.