Analyze your screen

Use Analyze to solve a coding task, test question or diagram on your screen, add more screenshots and ask about the result.

Windows and Mac · 2 min read

What it does

When a task is on your screen, such as a coding problem, a quiz or a diagram, Analyze reads it and writes the solution. MeetAssist hides itself for the screenshot, so it is not in the picture.

  1. 1.

    Show the task

    Make sure the task is visible on the screen MeetAssist reads.

  2. 2.

    Press Analyze

    Rest the pointer on Analyze, click it, or press the shortcut.

  3. 3.

    Read the result

    The panel shows Analyzing screen..., then the answer. Code and its explanation sit side by side when the panel is wide enough.

ActionMacWindows
Analyze screen⌘⇧SCtrlShiftS
An analysis: the code on the left, the explanation on the right.

The top of the panel

  • Screens to analyze: the screenshots the answer is based on. Hover one to see it larger.
  • Add screenshot: scroll to the rest of the task, or the next page, then click it. All screenshots are read again together as one task.
  • 1 of 10: how many screenshots are in use. Up to 10. Once there are two or more, each has a × to remove it.
  • Close: closes the analysis.

More than one monitor

By default Analyze reads the screen MeetAssist is on. To pick another before a session, see Screen analysis preferences. During one, a Display row with your screens appears at the bottom of the panel when you move the pointer over it. Click another screen and the same moment is read from it; that screen is used for the next Analyze too.

Good to know

  • Type in the follow-up line to ask about the solution. The reply sees the screenshots too.
  • What was said when you pressed Analyze goes along, so a question asked out loud about the task counts.
  • While an analysis is open, automatic answers wait. Press Answer for a question, or close the panel to let them go on.
  • Moving the pointer over Answer does not cancel a running analysis. Clicking Answer does.
  • If nothing appears after 8 seconds, Retry shows next to the spinner.
  • The programming language and your own rules for Analyze are in Screen analysis preferences.

Still stuck?

Write to us. A real person answers, usually the same day.

Contact support